Paul,
Use flush cutters and trim them as close as you can. Yes, that 1mm
matters. If you do not trim them, the LCD will contact the metalwork on
the front panel assembly and may break when you put things all together.
73,
Don W3FPR
On 1/19/2013 5:35 PM, Paul Roche wrote:
I am getting ready to install my backlight on my unbuilt K1. Step #1 is
³flush-trim all component leads which are located BETWEEN the two rows of
LCD PC board pads...²
Does this mean to flush-trim the pins of the U1 HOLDER? These pins are only
1 mm above the board. Am I really supposed to try to cut these even closer
to the board? Must the Insulator card assembly be perfectly flat on the
board, or is being 1 mm above the board fine?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
