I am getting ready to install my backlight on my unbuilt K1. Step #1 is ³flush-trim all component leads which are located BETWEEN the two rows of LCD PC board pads...²
Does this mean to flush-trim the pins of the U1 HOLDER? These pins are only 1 mm above the board. Am I really supposed to try to cut these even closer to the board? Must the Insulator card assembly be perfectly flat on the board, or is being 1 mm above the board fine? Thanks. Paul K3STX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
