I have a very similar problem. Some files get transferred and the P3 reports that it is on 1.24 but other FPGA files fail with the utility claiming that it is not responding.
Stephen G4SJP On 19 January 2013 06:32, Charlie Delta <[email protected]> wrote: > Hi Paul > > I have had all sorts of problems trying to update to this beta release. > > The upload crashed after the MCU load. I tried several times with no > success. > It seems that something gets corrupted after the reset process. > The P3 does actually reset however the update to the P3 Utility seems > rather slow. > > I even tried using the MCU bootloader with the same failure. I have tried > about 6 > times and it has failed on every attempt. I thought that it was the > USB-serial driver that got corrupted. I tried a dedicated RS232 port on > another PC with the same result. > I also disconnected the K3 from the P3 with no success. > > I have successfully loaded the previous beta so I presume that their is no > issue > with my PC setup. This might be some issue with my P3, although its running > fine after re- installing the previous beta. > > Is there something different in this beta release that makes loading > problematic? > > Craig > VK3OD > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
