This is a P3 bug that I believe was resolved in the most recent P3 firmware version, 01.16.
You should also upgrade to the most recent P3 Utility before installing P3 firmware version 01.16. Try power cycling the P3 just before attempting to connect the P3 Utility. 73 de Dick, K6KR. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dan Lynch Sent: Saturday, May 12, 2012 5:35 AM To: [email protected] Subject: [Elecraft] P3 Major Problem It appears my P3 has died after 9 months of flawless operation. Yesterday I updated the firmware to windows ver 1.12.4.26 (MCU1.16). The K3 has MCU 4.48 All worked fine for about an hour then the P3 lost everything. The P3 black screen reads: ****FATAL ERROR*** In: ddc_set_coef () SPAN=0 * The P3 Utility can not connect to the P3 either. It attempts to connect using different data rates but is unsuccessful. Any ideas? Dan....k0uif ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
