Idea: Follow the instructions on p23 of the Rev C P3 manual (lower left) to force a firmware load. This involves a few steps, but they're easy to follow.
If that doesn't work, don't despair. If it's broke, Elecraft can fix it. Contact support. 73, matt W6NIA On Sat, 12 May 2012 06:34:37 -0600, you wrote: >It appears my P3 has died after 9 months of flawless operation. > >Yesterday I updated the firmware to windows ver 1.12.4.26 (MCU1.16). >The K3 has MCU 4.48 > >All worked fine for about an hour then the P3 lost everything. > >The P3 black screen reads: > >****FATAL ERROR*** >In: ddc_set_coef () >SPAN=0 >* > >The P3 Utility can not connect to the P3 either. It attempts to connect >using different data rates but is unsuccessful. > >Any ideas? >Dan....k0uif >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
