Thanks Don, that did the trick! --Dave, W5SV / NNN0SLA
On 4/4/11 1:17 PM, Don Wilhelm wrote: > Dave, > > Yes there is an easy way, just turn the SHIFT knob to set the center > frequency (while adjusting, it is displayed in the VFO B area) - the > default is 1500 Hz. The since you want to use a 1 kHz width, adjust > the WIDTH knob until you see 1.00 in the VFO B display area. If the > SHIFT and WIDTH LEDs are not illuminated, tap one of the knobs to > switch from the LO - CUT - HI selection. > > If you use these adjustments frequently, they can be saved in one of > the presets. > > 73, > Don W3FPR > > On 4/4/2011 1:11 PM, David F. Reed wrote: >> When I am using MT63 in MARS service (1 KHz wide), we use a center >> frequency of 1KHz, so a pass band from 500 Hz to 1500 Hz; when I set >> date mode, and pick either the 2.7 KHz or 2.1 KHz filter, the data mode >> seems to cut off at a lower frequency of 1 KHz or so; is there an easy >> way to shift the pass band down where I want it? >> >> Thanks and 73 de Dave, W5SV / NNN0SLA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
