Dave, Yes there is an easy way, just turn the SHIFT knob to set the center frequency (while adjusting, it is displayed in the VFO B area) - the default is 1500 Hz. The since you want to use a 1 kHz width, adjust the WIDTH knob until you see 1.00 in the VFO B display area. If the SHIFT and WIDTH LEDs are not illuminated, tap one of the knobs to switch from the LO - CUT - HI selection.
If you use these adjustments frequently, they can be saved in one of the presets. 73, Don W3FPR On 4/4/2011 1:11 PM, David F. Reed wrote: > When I am using MT63 in MARS service (1 KHz wide), we use a center > frequency of 1KHz, so a pass band from 500 Hz to 1500 Hz; when I set > date mode, and pick either the 2.7 KHz or 2.1 KHz filter, the data mode > seems to cut off at a lower frequency of 1 KHz or so; is there an easy > way to shift the pass band down where I want it? > > Thanks and 73 de Dave, W5SV / NNN0SLA > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
