Thanks for the quick reply. I followed that procedure, but when I press K3 power on I get only MCU LD and tx red led blinking. How do I recover from this? Phil K3TUF
On 10/16/2010 8:24 PM, Dick Dievendorff wrote: > Disconnect p3 power plug. Remove K3 power by pulling its power plug. Stop K3 > utility. Plug k3 power back in and press K3 power on. Do not power on P3. > Start k3 utility and load K3 firmware. Then restore P3 power. > > Newest P3 manual has this info > > > Dick, K6KR > > > Sent from my iPhone > > On Oct 16, 2010, at 17:04, Phil Theis<[email protected]> wrote: > >> Got new P3 and worked fine. >> Went to load new firmware. >> Gave error dialog that needed to turn off P3 >> Turned off P3 >> Now K3 is in mid stream says MCU LD >> K3 Utility is just looping saying "Attempting to contact K3" at various >> speeds. >> Am I up the creek? >> What is my next step to get K3 back? >> Phil K3(352)TUF >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
