Hi Ron,
The masking material is the pieces of tape, usually green, around each
hole. I found a sharp "case cutter" edge was necessary to remove it. You
should have nice, shiny bare metal around the holes on the inside of each
panel. That will make sure you get good RF shielding. The rest of the
overspray on the won't hurt anything.
--Mike WQ5C
K2 #4693
At 06:47 PM 4/3/2005, Ron McMurray wrote:
pg # 29 removing masking material , are they talking about the grey overspray
ron, kc0tdj
#4857
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
