Le lundi 22 octobre 2007 à 11:52 +0100, Philippe Laliberte a écrit : > ael wrote: > > P laliberte wrote: > > > > > ael wrote: > > > > > > > Philippe Laliberte wrote: > > > > > > > > > > > > > Hello, > > > > > > > > > > I am running into a little problem. I did dig into the wiki but to no > > > > > avail. > > > > > > > > > > Set-up: > > > > > > > > > > Fedora 7. > > > > > kernel-2.6.22.9 > > > > > Firewall disabled. selinux disabled > > > > > Ekiga 2.0.11 > > > > > > > > > > Router Modem ADSL SpeedTouch 780 > > > > > Firewall disabled (once I get Ekiga working I'll test what I can > > > > > close) > > > > > VoIp turned off > > > > > > > > > > Modem routing Configuration > > > > > > > > > > Protocol Port Range Translate To ... Trigger Protocol > > > > > Trigger Port Any 5000 - 5100 5000 - 5100 > > > > > - - > > > > > UDP 3479 - 3479 3479 - 3479 > > > > > UDP 3479 > > > > > UDP 3478 - 3479 3478 - 3479 > > > > > UDP 3478 > > > > > > > > > > > > > > I can't quite decode the above. If you trigger on 3478 (UDP) and then > > > > open 5000 -5100 (UDP) then it should be ok. I am not sure that is what > > > > you have above is it? I can't make out the first line ending in > > > > 5000-5100: how does that relate to the two following lines? > > > > > > > > ael > > > > _______________________________________________ > > > > ekiga-list mailing list > > > > ekiga-list@gnome.org > > > > http://mail.gnome.org/mailman/listinfo/ekiga-list > > > > > > > > > > > Just missing a cariage return > > > > > > Protocol Port Range Translate To ... Trigger Protocol Trigger > > > Port Any 5000 - 5100 5000 - 5100 - - > > > UDP 3479 - 3479 3479 - 3479 UDP 3479 > > > UDP 3478 - 3479 3478 - 3479 UDP 3478 > > > > > > > > > What you mean is that I should just do : > > > > > > UDP 5000 - 5100 3479 - 3479 UDP 3479 > > > UDP 5100 - 5100 3478 - 3479 UDP 3478 > > > > > > > Looking at that again, why are you translating 3479 into 5000-5100? Or > > am I misunderstanding the web interface (I assume)? > > > > Once you see a packet on 3478, then open 5000-5100. Do not translate > > 3478 into 5000... if that is what the above means. 3478 and 3479 should > > be (con) tracked properly by the router. It is just that it will block > > 5000-5100 unless it is told otherwise. > > > > I have not encountered a SpeedTouch router so I may be misunderstanding > > its configuration. > > > > ael > > > The error is mine, late doing too many thing at the same time. You did > understand it correctly the first time. > > UDP 5000 - 5100 5000 - 5100 UDP 3479 > UDP 5100 - 5100 5000 - 5100 UDP 3478 > I'll test it later this afternoon thanks. >
Why 5100 - 5100 ? -- _ Damien Sandras (o- //\ Ekiga Softphone : http://www.ekiga.org/ v_/_ NOVACOM : http://www.novacom.be/ FOSDEM : http://www.fosdem.org/ SIP Phone : sip:[EMAIL PROTECTED] _______________________________________________ ekiga-list mailing list ekiga-list@gnome.org http://mail.gnome.org/mailman/listinfo/ekiga-list
