On Mon, Feb 3, 2014 at 5:36 AM, Anton Matsiuk <anton.mats...@gmail.com> wrote: > Dear all, > > I install Layer 1 Flow Rules (namely: Port 1 ->Port 2, Port 2 -> Port 1) > from Open Flow controller (as well as through ovs-ofctl): > ovs-ofctl add-flow br0 in_port=1,idle_timeout=0,actions=output:2 > I use 1000 test L4 UDP flows (with various dst.ports) to test the Switch > with 1000 of packets in each 64 bytes size and ~0.2 Mpps rate > > 1. When I put test traffic into incoming port I see that it installs 1000 > flows into its datapath with L4 granularity: > > in_port(2),eth(src=00:9c:02:ad:4e:1e,dst=00:9c:02:ad:4e:22),eth_type(0x0800),ipv4(src=10.0.0.1,dst=10.0.0.2,proto=17,tos=0,ttl=64,frag=no),udp(src=33864,dst=10864), > packets:350, bytes:21000, used:-0.004s, actions:1,3 > > Is it correct behavior of OVS's internal logic? Shiould datapath install L1 > flows or L4 flows in such case? I use ovs_version: "2.0.0"
Are you also using the kernel module shipped with OVS 2.0? _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
