Hey, I followed the configuration example and the FAQ. My specific
configuration is as follows:
sudo ovs-vsctl add-br br0
ovs-vsctl add-bond br0 bond0 eth1 eth2
But the sflow data caught by the host with the collector IP still does not have
the package through the bridge. What other configuration that I need to follow
if I want to get the sflow data about the bandwidth usage of the br0 and the
package through br0?
Thanks a lot.
Weiyu
________________________________________
From: Justin Pettit [jpet...@nicira.com]
Sent: Sunday, December 01, 2013 4:38 PM
To: WEIYU LIU
Cc: discuss@openvswitch.org discuss
Subject: Re: [ovs-discuss] Using OVS+Host sFlow to monitor network traffic
Please keep this on the mailing list. The man page should be with your OVS
distribution ("man ovs-vsctl"). It's also in the Documentation tab of the Open
vSwitch web site.
--Justin
On Dec 1, 2013, at 3:36 PM, WEIYU LIU <weiyu....@utah.edu> wrote:
> Thanks very much for your reply. Not yet. Would you please send me the
> address of this page? Thanks.
>
> Weiyu
> From: Justin Pettit [jpet...@nicira.com]
> Sent: Sunday, December 01, 2013 4:31 PM
> To: WEIYU LIU
> Subject: Re: [ovs-discuss] Using OVS+Host sFlow to monitor network traffic
>
> On Sun, Dec 1, 2013 at 11:24 AM, WEIYU LIU <weiyu....@utah.edu> wrote:
> I used OVS to create a bridge to connect two subnets. And then I created an
> sflow and attached it to the bridge. But it does not send sflow data to the
> collector. I also installed a Host sFlow on that server, but it just monitors
> the local server's performance. I am wondering how can I let the ovs send
> sflow data to the configured collector or how can I connect the Host sFlow to
> OVS to let it monitor the traffic on the virtual bridge. I will really
> appreciate if you can give me some advice. Thanks a lot.
>
> Did you try the example configuration in the ovs-vsctl man page?
>
> --Justin
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss
