No, no additional setup should be necessary. It's not obvious to me what your problem is.
On Sun, Feb 19, 2012 at 04:33:46PM +0530, sachin sharma wrote: > Hi Ben, > Do I also need to enable in-band stuff at the datapath ports as well? I > just added the datapath port as explained in INSTALL.Linux and then setted up > the controller as you explained in last mail. I am not observing any packet > exchange in the tcpdump output of datapath ports. My set up is => switch > A, B and C connected in a linear way and the controller is connected to > switch B. So in this setup, I am interested that the controller traffic of > the switch A and C should go via datapath ports connected to switch B. > > > thanks, > Sachin > > > > ________________________________ > From: Ben Pfaff <b...@nicira.com> > To: sachin sharma <sharon_sac...@yahoo.co.in> > Cc: "discuss@openvswitch.org" <discuss@openvswitch.org> > Sent: Wednesday, 15 February 2012 6:04 PM > Subject: Re: [ovs-discuss] how to enable inband communication > > On Wed, Feb 15, 2012 at 08:02:05PM +0530, sachin sharma wrote: > > I found the design of inband communication at openvswitch via DESIGN > > file in the openvswitch. However, i did not find the exact steps to > > configure this in our switches. > > In-band control is enabled by default when you configure a controller. > You can use "ovs-vsctl set-controller <bridge> <controller>" to > configure a controller. _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
