Hi,
I found the design of inband communication at openvswitch via DESIGN file in
the openvswitch. However, i did not find the exact steps to configure this in
our switches.
I have a setup of following nodes linked in a linear way:
Server-----OpenVswitch-A--------------OpenVswitch-B--------------OpenVswitch-C-----------Server
Where openvswitch C is connected to the NOX controller. What commands should I
run in the openvswitches A,B and C to enable inband communication via NOX
controller which is attached to openvswitch C.
May thanks in advance!
Best Regards,
Sachin
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss
