On Sun, Jul 10, 2011 at 02:26:01AM +0800, 沒 wrote: > * first question * > if I want to make Domain-0 link to be connected, which port should I attach > to the virtual bridge... eth0? or peth0?
I don't understand this question. You have one Ethernet port. Attach that one to vbr0. Where does the other one come from? > * second question * > do I need to attach "vif0.0" to the virtual bridge "vbr0"? (vif0.0 -> > interface of Domain0's eth0) > or there is no need to do so, just attach eth0 / peth0? If you want packets from vif0.0 to be able to reach eth0, and vice versa, then attach both of them to the same bridge. > * third question * > how can I attach "vif1.0" to "vbr0" before Domain-1 is been created? Normally you would attach vif1.0 to vbr0 after Domain-1 is created. > * forth question * > with KVM support, INSTALL.KVM says that need to add scripts ovs-ifup / > ovs-ifdown, > then, with XEN support system, do we need to write scripts for ifup / ifdown > commands? Yes, you need to make the corresponding changes to Xen. _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
