Hello ,

   Regarding the wireshark packet flow stop i think Dr Basti gave a
solution on his website . I think i got it Mr.Marcus Muller , the solution
for the last question but still working on its implementation verification

Thanks and regards ,
Ranganathan Sampathkumar

On Sat, Feb 15, 2020 at 2:39 PM Marcus Müller <muel...@kit.edu> wrote:

> Hi,
>
> slightly will have to repeat myself:
>
> On 15.02.20 21:15, sampath ranga wrote:
> > Hello Everyone,
> >
> >     1. I was trying for the past few weeks to make the Zigbee Trx
> > communicate with the other Zigbee hardware for implementation
> > verification . I am not using TelOS b mote with COntiki Firmware
> > instead i am using a Zigbee dongle as a hardware to make the
> > communication work . My question is why is the flowgraph restricting
> > only to hear the "hello world" message but not the message from other
> > hardware? If my SDR could operate at 2.4GHz in air , the transceiver
> > block should not only hear the "GNU Radio Transmitted message but also
> > from the other hardware isnt it? The other hardware is also not
> > receiving the GNU Radio's message.
>
> This is wireless communications. Not only do you have to configure all
> devices in a compatible manner, channel and receiver conditions can make
> interoperation problematic.
>
> You will have to apply your own signal processing / wireless education
> to debug this.
>
> >   2. Is the Rime stack / MAC layer that fixes frames stopping the
> > other hardware to send or receive?
>
>
> I don't understand this question, sorry.
>
> >   3. I am also trying the same Zigbee Trx in 2 laptops, the message
> > that i set in laptop 1 at GNU Radio Zigbee TRX has been received in
> > wireshark at laptop 1 and laptop 2 message at laptop 2 , Why are not
> > they syncing with each other if i give same destination or pan id with
> > channel number?
>
> Same answer as to 1. You're not doing any signal-level debugging on
> this, so we can't help you.
>
> > Technically i am trying to do 2 work , Either have two laptop that has
> > each flowgraph with 2 different message and wanna see if they both are
> > transferring their message at wireshark, which is right now not happening
> Same answer as to 1.
> > secondly , trying to transmit Zigbee Trx basti's message to a seperate
> > zigbee hardware (Xbee or any zigbee sniffer) or send message from Xbee
> > and trying to receiving in on Wireshark at the GNU Radio end
>
> Same answer as to 1.
>
> > I also face the issue of when i transceive the message its showing
> > "Bad FCS"  and also the packet flow is getting stopped when i open the
> > wireshark . Please throw some ideas on this .
> >
> Same answer as to 1.
>
>

Reply via email to