On 06/14/2016 02:37 PM, Santos Campos wrote:
Hello, all!
This may be more of a board specific problem, so apologies if this is
the wrong place to ask.
I'm sending a tone from one b200 usrp to a receiving one. I was trying
to recover the frequency of the original tone and was able to do so
while only receiving.
However, when I tried to add a transmitting functionality, it seems
that my received samples are "corrupted" and the frequency I was
trying to recover bounces all over the place. I was pretty sure that
they supported full duplex, so I'm not sure what it might be.
Any thoughts and suggestions are much appreciated!
-Santos
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
So, another thing that leaps out at me is that your signal source and
many of the intervening processing blocks think that they're operating
at 32K, when in fact, they'll be operating at the hardware rate of your
sink of 40.96ksps. The "math" will be all wrong. Either adjust the
parameters of your intervening blocks so that they know you're operating
at 40.96ksps, or put in an interpolator.
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
