On 06/14/2016 02:37 PM, Santos Campos wrote:
Hello, all!
This may be more of a board specific problem, so apologies if this is
the wrong place to ask.
I'm sending a tone from one b200 usrp to a receiving one. I was trying
to recover the frequency of the original tone and was able to do so
while only receiving.
However, when I tried to add a transmitting functionality, it seems
that my received samples are "corrupted" and the frequency I was
trying to recover bounces all over the place. I was pretty sure that
they supported full duplex, so I'm not sure what it might be.
Any thoughts and suggestions are much appreciated!
-Santos
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
You'll need to give more details of your setup. Are you transmitting on
the same frequency as you're receiving? How are you antennas setup?
Within the B200 itself, there's roughly 40dB of isolation between TX and
RX, so the RX side will be able to "see" your transmissions, and even if
you're on a different frequency for RX, if the TX and RX pathways are
close, so that there's little path-loss, the analog RX chain will almost
certainly be driven into non-linear operating.
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
