Hello, Johnathan I have faced the same problem. I try to received the limited samples from USRP2 by using "head"block. It should return a -1 and the flow graph will stop, am I right?
Then I call myblock.run() again during the while loop for several times. However, after running the loop for more than three times, the message repeated as below without any other output anymore. usrp2: channel 0 not receiving usrp2::rx_samples() failed I am a bit confused since I have already updated all the packages in synaptic package manager. The newest version is 3.2.2-1. Should I updated anything else to solve this problem? Other examples related to USRP2 such as usrp2_fft and usrp2_display did not have such problem. Thank you. best regards, Andy Johnathan Corgan-2 wrote: > > On Tue, 2010-02-16 at 13:47 -0800, Veljko Pejovic wrote: >> Is it possible to dynamically reconfigure a flow graph that has a usrp2 >> source? > > Yes. > >> I tested a simple lock()/unlock() from the top graph, and also from >> the other parts of the graph. I always get the following error: >> >> usrp2: channel 0 not receiving >> usrp2::rx_samples() failed > > Are you using 3.2.2? If so, I think this is a bug that was fixed in our > development since then. > > Johnathan > > > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > http://lists.gnu.org/mailman/listinfo/discuss-gnuradio > > -- View this message in context: http://old.nabble.com/reconfiguring-with-usrp2-src-present-tp27615622p28247109.html Sent from the GnuRadio mailing list archive at Nabble.com. _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
