Hi Eric, Thanks very much for your reply.
I tried to verify the bin that I programmed in the SD card using -v option. No error message and no success message either. But if I plug in the SD card to the USRP2, I still cannot get any LED on. Do you know what could cause this problem? Thanks! Regards, Yabo On Tue, Jan 27, 2009 at 2:32 AM, Eric Blossom <e...@comsec.com> wrote: > On Mon, Jan 26, 2009 at 11:15:15PM -0800, Yabo Li wrote: > > Hi, > > > > I tried to follow the instructions in "USRP2UserFAQ" to program the SD > card > > with the bin files from http://gnuradio.org/releases/usrp2-bin/trunk/. > > (txrx.bin and u2_rev3.bin), there is no error message showing up. > However, > > when I plug in the SD card into USRP2, and power on, I cannot get normal > led > > lights as I usually get with the right SD card. Is there anyway to verify > > that I indeed programmed the SD card, or verify that what I programmed > > matches with the bin files? BTW, I am using a 2G SD card. Thanks! > > > > Regards, > > Yabo > > $ u2_flash_tool --help > Usage: u2_flash_tool: [options] filename > > Options: > -h, --help show this help message and exit > -w, --write write FILE to TARGET slot > -v, --verify verify FILE against TARGET slot > -r, --read read TARGET slot, write to FILE > -t TARGET, --target=TARGET > select TARGET slot from: fpga, s/w [default=s/w] > --dev=DEV specify flash device file, e.g., /dev/sdb. Be > careful! >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
