Johnathan Corgan wrote:
On 1/21/08, George Nychis <[EMAIL PROTECTED]> wrote:
When running usrp_rx_cfile.py the first time, i get no voltage reading
from this pin.
Then I run usrp_siggen.py and get a little under 1V at the pin on average.
When I stop usrp_siggen.py the pin goes down to about 200mV, which is
where it stays when i run usrp_rx_cfile.py the second time.
This should be a 3.3V logic level. Can you verify you have the right pin?
I've drawn a red arrow to where I'm measuring from:
http://www.andrew.cmu.edu/user/gnychis/Flex2400.jpg
- George
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
