Johnathan Corgan wrote:
On 1/21/08, George Nychis <[EMAIL PROTECTED]> wrote:
I have a logic analyzer and RFX2400 board handy that I can test this
out. Which pin is the mixer chip enable pin?
U101, pin 8.
When running usrp_rx_cfile.py the first time, i get no voltage reading
from this pin.
Then I run usrp_siggen.py and get a little under 1V at the pin on average.
When I stop usrp_siggen.py the pin goes down to about 200mV, which is
where it stays when i run usrp_rx_cfile.py the second time.
- George
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
