NOTE: This API is not supported in initial Jolla device software. It will be available from 1.0.2.* and later Sailfish OS releases. # Enable VDD echo 1 > /sys/devices/platform/reguserspaceconsumer.0/state # Disable VDD echo 0 > /sys/devices/platform/reguserspaceconsumer.0/state
So unfortunately you have to wait for next update before you can unable 3.3V pin from user space. But that should happen 'soon'... ________________________________ From: devel-boun...@lists.sailfishos.org [devel-boun...@lists.sailfishos.org] on behalf of Kimmo Lindholm [kimmo.lindh...@eke.fi] Sent: Monday, December 23, 2013 4:49 PM To: devel@lists.sailfishos.org Subject: [SailfishDevel] The Other Half I2C Anchors aweigh! Just hooked up scope to I2C bus on pogo pins, and there is life! Can someone point me in correct direction to enable 3.3V pin? 3.3V seems to be active just for a while when I press the cover detector switch and after eeprom in address 0x50 is tested 3.3V is gone. Best Regards, ----------------- --... ...-- -.. . --- .... ..--- .... --.- .--. ---------------- Kimmo Lindholm Hardware and Platform Development Manager EKE-Electronics Ltd. Piispanportti7, FI-02240 Espoo, Finland Tel. +358 9 6130 3305, fax +358 96130 3300, mobile +358 40 500 0081 kimmo.lindh...@eke.fi www.eke.com<http://www.eke.com> This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed.
_______________________________________________ SailfishOS.org Devel mailing list
