On Thu, Nov 21, 2013 at 12:46:42PM +0900, Simon Horman wrote:
> The aim of this patch is to support provide infrastructure for verification
> of VLAN actions after an mpls_push action for OpenFlow1.3. This supplements
> existing support for verifying these actions for pre-OpenFlow1.3.
>
> In OpenFlow1.1 and 1.2 MPLS tags are pushed after any VLAN tags that
> immediately follow the ethernet header. This is pre-OpenFlow1.3 tag
> ordering. Open vSwitch also uses this ordering when supporting MPLS
> actions via Nicira extensions to OpenFlow1.0.
>
> When using pre-OpenFlow1.3 tag ordering an MPLS push action does not
> affect the VLANs of a packet. If VLAN tags are present immediately after
> the ethernet header then they remain present there.
>
> In of OpenFlow1.3+ MPLS LSEs are pushed before any VLAN tags that
> immediately follow the ethernet header. This is OpenFlow1.3+ tag
> ordering.
>
> When using OpenFlow1.3+ tag ordering an MPLS push action affects the
> VLANs of a packet as any VLAN tags previously present after the ethernet
> header are moved to be immediately after the newly pushed MPLS LSE. Thus
> for the purpose of action consistency checking a packet may be changed
> from a VLAN packet to a non-VLAN packet.
>
> In this way the effective value of the VLAN TCI of a packet may differ
> after an MPLS push depending on the OpenFlow version in use.
>
> This patch does not enable the logic described above.
> Rather it is disabled in ofpacts_check__(). It should
> be enabled when support for OpenFlow1.3+ tag order is added
> and enabled.
>
> Signed-off-by: Simon Horman <ho...@verge.net.au>
As far as I can tell this doesn't make sense, because where the MPLS
tag goes is a property of the action that we know at the time we parse
the push_mpls action. So why isn't this patch just the following?
diff --git a/lib/ofp-actions.c b/lib/ofp-actions.c
index a02f842..f444374 100644
--- a/lib/ofp-actions.c
+++ b/lib/ofp-actions.c
@@ -2071,6 +2071,9 @@ ofpact_check__(enum ofputil_protocol *usable_protocols,
struct ofpact *a,
* Thus nothing can be assumed about the network protocol.
* Temporarily mark that we have no nw_proto. */
flow->nw_proto = 0;
+ if (ofpact_get_PUSH_MPLS(a)->position == OFPACT_MPLS_BEFORE_VLAN) {
+ flow->vlan_tci = 0;
+ }
return 0;
case OFPACT_POP_MPLS:
_______________________________________________
dev mailing list
dev@openvswitch.org
http://openvswitch.org/mailman/listinfo/dev
