Hi Brennen, I have not tested with vscode in a bit. But the issue for me before was the edit ability of registers on IP blocks and CPU. Ben may be referring to the hard fault debugging technique I presented at the NuttX conference 2 years ago. It is a simple cut and paste from the LR to the IP regs in the eclipse GUI, and IIRC a ton of typing in VS code or read only. Has that improved?
David -----Original Message----- From: Brennan Ashton [mailto:bash...@brennanashton.com] Sent: Wednesday, December 09, 2020 5:59 PM To: dev@nuttx.apache.org Subject: Re: about IDEs and dev boards Marlar With the plugin that I linked you should be able to nice debugging without having to use two different environments. Just don't use the native vscode debugger from the c++ it has long standing issues with remote targets. Ben is there a reason you don't use it for hardfaults? I'm not sure I quite understand what you would run into with that. --Brennan On Wed, Dec 9, 2020, 5:30 PM Marlar Chan <marlar.c...@ntu.edu.sg> wrote: > Dear Ben, > Is there any setup guideline for Nuttx debuggig with VSCode (normal > use) and Eclipse (Hard faults)? > > Best Regards, > Marlar > ________________________________ > From: Disruptive Solutions <disruptivesolution...@gmail.com> > Sent: Wednesday, December 9, 2020 6:16 PM > To: dev@nuttx.apache.org <dev@nuttx.apache.org> > Subject: Re: about IDEs and dev boards > > VSCode (normal use) and Eclipse (Hard faults). > > STM32 stack (nucleos, blackboards, etc) and own reference board(s). > > Hardware as extra tools (logic analyzer, scope, seggers, st link, etc) > > And just having fun to use NuttX and the results one can achieve..... > Still > mind blowing!!! > > Ben > > Op wo 9 dec. 2020 8:39 a.m. schreef Marc Rosen <ma...@zeitcontrol.de>: > > > > > Am 04.12.2020 um 02:54 schrieb Matias N.: > > > Hi, > > > I was wondering what IDEs do you use with NuttX and what is your > > preferred dev board (can be more than one). > > > I'm curious since I have used QtCreator for long time now and > > > generally > > works well, but it has some quirks. > > Jetbrains CLion is the IDE i use. It is not that great with Makefile > > projects and debugging but it is getting better. > > And it works well if you also use some of their other dev tools and > > ides. > > > And on hardware side I always favored STM32 boards (with embedded > > debugger) but after getting into nRF52 I found > > > it to be much easier to work with and seems a very well designed SoC > > from the users perspective. The "mux (almost) any peripheral to any pin" > is > > great (any other chip does that?). > > > > > > Best, > > > Matias > > Mostly AVRs here, the ones too small for Nuttx, and STM32. Usually > > custom boards. > > > > regards, > > Marc > > > > > ________________________________ > > CONFIDENTIALITY: This email is intended solely for the person(s) named and > may be confidential and/or privileged. If you are not the intended > recipient, please delete it, notify us and do not copy, use, or disclose > its contents. > Towards a sustainable earth: Print only when necessary. Thank you. >
