Well, I don't know how to explain, but I was reviewing here the process for setup, writing down the commands that I used ... and now everything is working fine. :-/
Maybe during yesterday's tests maybe something may be lost during menuconfig. I am sorry for the inconvenience. But ... maybe I found my answer. I believe that the nucleo-f429zi:netnsh is the configuration that I was looking for. The problem that I am facing now is that is that the network interface is not initializing: nsh> ifconfig nsh: ifconfig: opendir failed: 20 Best regards,, Flavio Em sex., 18 de set. de 2020 às 20:16, Brennan Ashton <bash...@brennanashton.com> escreveu: > > On Fri, Sep 18, 2020 at 3:16 PM Flavio Castro Alves Filho > <flavio.al...@gmail.com> wrote: > > > > Hello Matias, > > > > Em sex., 18 de set. de 2020 às 16:26, Matias N. <mat...@imap.cc> escreveu: > > > > > > Hi Flavio, > > > please have a look at our new documentation, which you may find helpful: > > > > > > https://nuttx.apache.org/docs/latest/ > > > > > > > I did ... that's how I found most of the problems to have this initial > > version running. > > > > > Most boards have a "nsh" documentation which should be a good start (this > > > is also explained in the documentation). > > > > > > > ok. I will check this out. > > > > > I don't know the particular status of this board, but usually STM32 > > > boards are > > > well supported. > > > > > > > Probably there is something with this board. > > > > > Best, > > > Matias > > > > > > > Thank you for your response. > > > > Best regards, > > > > Flavio > > Flavio, > I do have the STM32F439ZI version which as far as NuttX is concerned > should be the same. I can give it a try this weekend, in the meantime > if you could post your steps and where you got stuck in an issue, we > can work through exactly what went wrong and fix the documentation. > > --Brennan -- Flavio de Castro Alves Filho flavio.al...@gmail.com Twitter: http://twitter.com/#!/fraviofii LinkedIn profile: www.linkedin.com/in/flaviocastroalves
