Hello Matias, Em sex., 18 de set. de 2020 às 16:26, Matias N. <mat...@imap.cc> escreveu: > > Hi Flavio, > please have a look at our new documentation, which you may find helpful: > > https://nuttx.apache.org/docs/latest/ >
I did ... that's how I found most of the problems to have this initial version running. > Most boards have a "nsh" documentation which should be a good start (this > is also explained in the documentation). > ok. I will check this out. > I don't know the particular status of this board, but usually STM32 boards are > well supported. > Probably there is something with this board. > Best, > Matias > Thank you for your response. Best regards, Flavio > On Fri, Sep 18, 2020, at 16:16, Flavio Castro Alves Filho wrote: > > Hello, > > > > I am studying NuttX for a new project. I am using Nucleo-F429ZI as > > reference, which is quite a complete board and has a large memory for > > testing. > > > > I followed some instructions from the internet (mostly from NuttX > > website) and I could compile and run a binary on the board. Including > > executing a Hello Application located at the menuconfig. > > > > My question is if there is an initial configuration file (defconfig) > > for this board that initializes the base features of the board. > > Something similar to an initial configuration on the STM32CubeIDE new > > project, where all the base peripherals (leds, buttons, ethernet, usb, > > serial, ...) are previously initialized. > > > > In my first test here, serial was not enabled, compilation failed and > > ls command in Nuttshell didn't work (only the call for the > > application). > > > > Best regards, > > > > Flavio > > > > -- > > Flavio de Castro Alves Filho > > > > flavio.al...@gmail.com > > Twitter: http://twitter.com/#!/fraviofii > > LinkedIn profile: www.linkedin.com/in/flaviocastroalves > > -- Flavio de Castro Alves Filho flavio.al...@gmail.com Twitter: http://twitter.com/#!/fraviofii LinkedIn profile: www.linkedin.com/in/flaviocastroalves
