Many thanks to you for your taking time to review this patch set. Thanks -Wei
> -----Original Message----- > From: Yigit, Ferruh > Sent: Thursday, December 22, 2016 1:20 AM > To: Dai, Wei <wei....@intel.com>; dev@dpdk.org > Cc: Zhang, Helin <helin.zh...@intel.com>; Ananyev, Konstantin > <konstantin.anan...@intel.com> > Subject: Re: [dpdk-dev] [PATCH v2 00/30] update ixgbe shared code to version > 16.11.21 > > On 12/21/2016 9:47 AM, Wei Dai wrote: > > update ixgbe shared code to version 16.11.21 . > > v2 changes: > > modify subject line and message body of git log according to > > feedbacks from communtiy. > > > > split the 24th patch into 2 separate ones. > > the 24th of v1 is net/ixgbe/base: add EEE support for DNL-controlled PHYs > > the 24th of v2 is net/ixgbe/base: add EEE support for some PHYs > > the 25th of v2 is net/ixgbe/base: remove unused enum type > > > > correct RAEDME > > > > Wei Dai (30): > > net/ixgbe/base: fix PHY reset check for x550em-ext > > net/ixgbe/base: fix clearing SAN MAC address > > net/ixgbe/base: use fast MDIO for non-10G devices > > net/ixgbe/base: fix PHY identification for x550a > > net/ixgbe/base: clean up X557 link status check > > net/ixgbe/base: add driver version to firmware > > net/ixgbe/base: store link active LED > > net/ixgbe/base: cleanup X540 checksum calculation > > net/ixgbe/base: enable LASI only for X552 devices > > net/ixgbe/base: limit iXFI setup to X552 devices > > net/ixgbe/base: fix getting PHY type for some x550 devices > > net/ixgbe/base: fix SGMII link setup for M88 PHYs > > net/ixgbe/base: cleanup dead EEE code > > net/ixgbe/base: fix setting unsupported autoneg speeds > > net/ixgbe/base: support FW commands to control some PHYs > > net/ixgbe/base: use FW commands to control some PHYs > > net/ixgbe/base: support busy SGMII register reads > > net/ixgbe/base: include new speeds in VFLINK interpretation > > net/ixgbe/base: limit 5Gb support to X550 devices > > net/ixgbe/base: add physical layer options for FW PHY type > > net/ixgbe/base: remove unneeded MAC type check > > net/ixgbe/base: remove unused PHY ID > > net/ixgbe/base: update FW PHY flow control > > net/ixgbe/base: add EEE support for some PHYs > > net/ixgbe/base: remove unused enum type > > net/ixgbe/base: fix IXGBE LSWFW register > > net/ixgbe/base: remove unused EEE code > > net/ixgbe/base: add write flush required by Inphi PHY > > net/ixgbe/base: report physical layer for SGMII PHY type > > net/ixgbe/base: update shared code version to 2016.11.21 > <...> > > Series applied to dpdk-next-net/master, thanks. >
