On Thu, Jun 02, 2016 at 09:36:34AM +0200, Olivier MATZ wrote:
> Hi Jerin,
>
> On 06/01/2016 09:00 AM, Jerin Jacob wrote:
> > On Tue, May 31, 2016 at 11:05:30PM +0200, Olivier MATZ wrote:
> >> Today, the objects pointers are reversed only in the get(). It means
> >> that this code:
> >>
> >> rte_mempool_get_bulk(mp, table, 4);
> >> for (i = 0; i < 4; i++)
> >> printf("obj = %p\n", t[i]);
> >> rte_mempool_put_bulk(mp, table, 4);
> >>
> >>
> >> printf("-----\n");
> >> rte_mempool_get_bulk(mp, table, 4);
> >> for (i = 0; i < 4; i++)
> >> printf("obj = %p\n", t[i]);
> >> rte_mempool_put_bulk(mp, table, 4);
> >>
> >> prints:
> >>
> >> addr1
> >> addr2
> >> addr3
> >> addr4
> >> -----
> >> addr4
> >> addr3
> >> addr2
> >> addr1
> >>
> >> Which is quite strange.
> >
> > IMO, It is the expected LIFO behavior. Right ?
> >
> > What is not expected is the following, which is the case after change. Or
> > Am I
> > missing something here?
> >
> > addr1
> > addr2
> > addr3
> > addr4
> > -----
> > addr1
> > addr2
> > addr3
> > addr4
> >
> >>
> >> I don't think it would be an issue to replace the loop by a
> >> rte_memcpy(), it may increase the copy speed and it will be
> >> more coherent with the put().
> >>
>
> I think the LIFO behavior should occur on a per-bulk basis. I mean,
> it should behave like in the exemplaes below:
>
> // pool cache is in state X
> obj1 = mempool_get(mp)
> obj2 = mempool_get(mp)
> mempool_put(mp, obj2)
> mempool_put(mp, obj1)
> // pool cache is back in state X
>
> // pool cache is in state X
> bulk1 = mempool_get_bulk(mp, 16)
> bulk2 = mempool_get_bulk(mp, 16)
> mempool_put_bulk(mp, bulk2, 16)
> mempool_put_bulk(mp, bulk1, 16)
> // pool cache is back in state X
>
Per entry LIFO behavior make more sense in _bulk_ case as recently en-queued
buffer
comes out for next "get" makes more chance that buffer in Last level cache.
> Note that today it's not the case for bulks, since object addresses
> are reversed only in get(), we are not back in the original state.
> I don't really see the advantage of this.
>
> Removing the reversing may accelerate the cache in case of bulk get,
> I think.
I tried in my setup, it was dropping the performance. Have you got
improvement in any setup?
Jerin
>
> Regards,
> Olivier
