Dear DPDK Development Team,
I hope this email finds you well. I am reaching out to inquire about *DPDK
support for the Marvell AQtion 10Gbit Network Adapter* on my system.
I am working on a *DPDK-based project* and considering integrating the *Marvell
AQtion 10Gbit NIC*.
*System Details:*
- *Motherboard:* ASUS ProArt Z790 Creator WiFi
- *Ethernet Interfaces:*
- *1st Interface:* Intel(R) Ethernet Controller I226-V (2.5 Gbit)
- *2nd Interface:* Marvell AQtion 10Gbit Network Adapter
- *DPDK Setup:*
- Installed DPDK and *vfio-pci* driver
- Successfully *bound* the 1st (2.5Gbit) interface to *vfio-pci*
- *Unable to bind* the 2nd (10Gbit) interface
*Issue:*
I followed the standard DPDK setup steps and was able to *bind and use the
2.5Gbit Intel interface* without issues. However, I *could not bind the
Marvell AQtion 10Gbit adapter* to DPDK.
Specifically, I would like to know:
1. Whether *Marvell AQtion 10Gbit NIC* is officially supported by DPDK.
2. If supported, which *DPDK driver* should be used for this NIC?
3. If not currently supported, are there any *workarounds* or plans for
future support?
I would appreciate any guidance, references, or recommendations regarding
this matter. Looking forward to your response.
Best regards,
Mamadaliev Dilshodjon
Master student in Pusan National University, Republic of Korea
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
Virus-free.www.avast.com
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
