From: Marvin Liu <yong....@intel.com>
e1000 only support one type of interrupt cause, so remove lsc interrupt
handler if rxq enabled.
Signed-off-by: Marvin Liu <yong.liu at intel.com>
diff --git a/drivers/net/e1000/em_ethdev.c b/drivers/net/e1000/em_ethdev.c
index 5d94b55..920d814 100644
--- a/drivers/net/e1000/em_ethdev.c
+++ b/drivers/net/e1000/em_ethdev.c
@@ -630,14 +630,22 @@ eth_em_start(struct rte_eth_dev *dev)
}
e1000_setup_link(hw);
- /* check if lsc interrupt feature is enabled */
- if (dev->data->dev_conf.intr_conf.lsc != 0) {
- ret = eth_em_interrupt_setup(dev);
- if (ret) {
- PMD_INIT_LOG(ERR, "Unable to setup interrupts");
- em_dev_clear_queues(dev);
- return ret;
- }
+ if (rte_intr_allow_others(intr_handle)) {
+ /* check if lsc interrupt is enabled */
+ if (dev->data->dev_conf.intr_conf.lsc != 0)
+ ret = eth_em_interrupt_setup(dev);
+ if (ret) {
+ PMD_INIT_LOG(ERR, "Unable to setup interrupts");
+ em_dev_clear_queues(dev);
+ return ret;
+ }
+ } else {
+ rte_intr_callback_unregister(intr_handle,
+ eth_em_interrupt_handler,
+ (void *)dev);
+ if (dev->data->dev_conf.intr_conf.lsc != 0)
+ PMD_INIT_LOG(INFO, "lsc won't enable because of"
+ " no intr multiplex\n");
}
/* check if rxq interrupt is enabled */
if (dev->data->dev_conf.intr_conf.rxq != 0)
@@ -687,6 +695,13 @@ eth_em_stop(struct rte_eth_dev *dev)
/* clear the recorded link status */
memset(&link, 0, sizeof(link));
rte_em_dev_atomic_write_link_status(dev, &link);
+
+ if (!rte_intr_allow_others(intr_handle))
+ /* resume to the default handler */
+ rte_intr_callback_register(intr_handle,
+ eth_em_interrupt_handler,
+ (void *)dev);
+
/* Clean datapath event and queue/vec mapping */
rte_intr_efd_disable(intr_handle);
if (intr_handle->intr_vec != NULL) {
--
1.9.3
