Acked-by: Xiaoyun Li <xiaoyun...@intel.com>
> -----Original Message-----
> From: Iremonger, Bernard <bernard.iremon...@intel.com>
> Sent: Tuesday, January 19, 2021 21:01
> To: dev@dpdk.org; Li, Xiaoyun <xiaoyun...@intel.com>
> Cc: Iremonger, Bernard <bernard.iremon...@intel.com>; sta...@dpdk.org
> Subject: [PATCH v2] doc: fix testpmd sample qinq flow rules
>
> In the Testpmd Flow rules management section, correct the TPID values in the
> Sample QinQ flow rules sub section.
> Also replace the keyword qinq_strip with extend in the vlan set command.
>
> Fixes: bef3bfe7d5f4 ("doc: revise sample testpmd flow commands")
> Cc: sta...@dpdk.org
>
> Signed-off-by: Bernard Iremonger <bernard.iremon...@intel.com>
> ---
> doc/guides/testpmd_app_ug/testpmd_funcs.rst | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
> b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
> index 9be4500..6a00245 100644
> --- a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
> +++ b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
> @@ -4426,14 +4426,14 @@ Sample QinQ flow rules Before creating QinQ
> rule(s) the following commands should be issued to enable QinQ::
>
> testpmd> port stop 0
> - testpmd> vlan set qinq_strip on 0
> + testpmd> vlan set extend on 0
>
> The above command sets the inner and outer TPID's to 0x8100.
>
> To change the TPID's the following commands should be used::
>
> - testpmd> vlan set outer tpid 0xa100 0
> - testpmd> vlan set inner tpid 0x9100 0
> + testpmd> vlan set outer tpid 0x88A8 0
> + testpmd> vlan set inner tpid 0x8100 0
> testpmd> port start 0
>
> Validate and create a QinQ rule on port 0 to steer traffic to a VF queue in
> a VM.
> --
> 2.7.4
