In the Testpmd Flow rules management section, correct
the TPID values in the Sample QinQ flow rules sub section.
Also replace the keyword qinq_strip with extend in the
vlan set command.
Fixes: bef3bfe7d5f4 ("doc: revise sample testpmd flow commands")
Cc: sta...@dpdk.org
Signed-off-by: Bernard Iremonger <bernard.iremon...@intel.com>
---
doc/guides/testpmd_app_ug/testpmd_funcs.rst | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
index 9be4500..6a00245 100644
--- a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
+++ b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
@@ -4426,14 +4426,14 @@ Sample QinQ flow rules
Before creating QinQ rule(s) the following commands should be issued to enable
QinQ::
testpmd> port stop 0
- testpmd> vlan set qinq_strip on 0
+ testpmd> vlan set extend on 0
The above command sets the inner and outer TPID's to 0x8100.
To change the TPID's the following commands should be used::
- testpmd> vlan set outer tpid 0xa100 0
- testpmd> vlan set inner tpid 0x9100 0
+ testpmd> vlan set outer tpid 0x88A8 0
+ testpmd> vlan set inner tpid 0x8100 0
testpmd> port start 0
Validate and create a QinQ rule on port 0 to steer traffic to a VF queue in a
VM.
--
2.7.4
