virtio 1.0 introduced a mechanism for the driver to verify that the
feature bits it sets are accepted by the device. This mechanism consists
in setting the VIRTIO_STATUS_FEATURE_OK status bit and re-reading it,
whitch gives a chance for the device to clear it if the the features
were not accepted.
This is currently being done only in modern virtio-pci devices but since
the appropriate vhost-user messages have been added, it can also be done
in virtio-user (vhost-user only).
This patch activates this mechanism on virtio-user.
Signed-off-by: Adrian Moreno <amore...@redhat.com>
---
drivers/net/virtio/virtio_ethdev.c | 13 +++++++------
1 file changed, 7 insertions(+), 6 deletions(-)
diff --git a/drivers/net/virtio/virtio_ethdev.c
b/drivers/net/virtio/virtio_ethdev.c
index dc0093bdf..9063bfeb2 100644
--- a/drivers/net/virtio/virtio_ethdev.c
+++ b/drivers/net/virtio/virtio_ethdev.c
@@ -1355,12 +1355,13 @@ virtio_negotiate_features(struct virtio_hw *hw,
uint64_t req_features)
PMD_INIT_LOG(DEBUG, "features after negotiate = %" PRIx64,
hw->guest_features);
- if (hw->modern) {
- if (!vtpci_with_feature(hw, VIRTIO_F_VERSION_1)) {
- PMD_INIT_LOG(ERR,
- "VIRTIO_F_VERSION_1 features is not enabled.");
- return -1;
- }
+ if (hw->modern && !vtpci_with_feature(hw, VIRTIO_F_VERSION_1)) {
+ PMD_INIT_LOG(ERR,
+ "VIRTIO_F_VERSION_1 features is not enabled.");
+ return -1;
+ }
+
+ if (hw->modern || hw->virtio_user_dev) {
vtpci_set_status(hw, VIRTIO_CONFIG_STATUS_FEATURES_OK);
if (!(vtpci_get_status(hw) & VIRTIO_CONFIG_STATUS_FEATURES_OK))
{
PMD_INIT_LOG(ERR,
--
2.26.2
