> -----Original Message-----
> From: Yigit, Ferruh
> Sent: Wednesday, November 13, 2019 22:38
> To: Xu, Rosen <rosen...@intel.com>; dev@dpdk.org
> Cc: Zhang, Tianfei <tianfei.zh...@intel.com>; Pei, Andy
> <andy....@intel.com>; Ye, Xiaolong <xiaolong...@intel.com>
> Subject: Re: [PATCH v16 01/19] net/i40e: i40e support ipn3ke FPGA port
> bonding
>
> On 11/13/2019 7:08 AM, Rosen Xu wrote:
> > From: Andy Pei <andy....@intel.com>
> >
> > In ipn3ke, each FPGA network side port bonding to an i40e pf, each
> > i40e pf link status should get data from FPGA network, side port. This
> > patch provide bonding relationship.
> >
> > Signed-off-by: Rosen Xu <rosen...@intel.com>
> > Signed-off-by: Andy Pei <andy....@intel.com>
>
> <...>
>
> > @@ -1061,4 +1061,22 @@ int rte_pmd_i40e_inset_set(uint16_t port,
> uint8_t pctype,
> > return 0;
> > }
> >
> > +/**
> > + * For ipn3ke, i40e works with FPGA.
> > + * In this situation, i40e get link status from fpga,
> > + * fpga works as switch_dev for i40e.
> > + * This function set switch_dev for i40e.
> > + *
> > + * @param inset
> > + * Input set value.
> > + * @param field_idx
> > + * Field index for input set.
>
> These params are wrong, can you please provide proper information, I can
> update them in next-net?
Fixed in v17.
> > + * @return
> > + * - (less than 0) if failed.
> > + * - (0) if success.
> > + */
> > +__rte_experimental
> > +int
> > +rte_pmd_i40e_set_switch_dev(uint16_t port_id, struct rte_eth_dev
> > +*switch_dev);
> > +
> > #endif /* _PMD_I40E_H_ */
> > diff --git a/drivers/net/i40e/rte_pmd_i40e_version.map
> > b/drivers/net/i40e/rte_pmd_i40e_version.map
> > index cccd576..79641f2 100644
> > --- a/drivers/net/i40e/rte_pmd_i40e_version.map
> > +++ b/drivers/net/i40e/rte_pmd_i40e_version.map
> > @@ -64,4 +64,10 @@ DPDK_18.02 {
> >
> > rte_pmd_i40e_inset_get;
> > rte_pmd_i40e_inset_set;
> > -} DPDK_17.11;
> > \ No newline at end of file
> > +} DPDK_17.11;
> > +
> > +EXPERIMENTAL {
> > + global:
> > +
> > + rte_pmd_i40e_set_switch_dev;
> > +} DPDK_18.02;
>
> The 'DPDK_18.02' part is not required for experimental block, I will remove it
> while merging.
Fixed in v17.
