On 10/9/2018 5:35 AM, chetan bhasin wrote:
> Thanks for your reply .
>
> The issue coming in function "vmxnet3_dev_tx_queue_setup"
>
> below if condition is true because "tx_conf->txq_flags is coming as 0"
>
> if ((tx_conf->txq_flags & ETH_TXQ_FLAGS_NOXSUMSCTP) !=
> ETH_TXQ_FLAGS_NOXSUMSCTP) {
> PMD_INIT_LOG(ERR, "SCTP checksum offload not supported");
> return -EINVAL;
> }
Hi Chetan,
In v17.11, all Tx offloads are enabled by default and can be disabled via
tx_conf->txq_flags.
Above code says PMD is not supporting SCTP checksum offload but you are
requesting it, by passing "txq_flags == 0", and PMD fails.
You need to pass at least "txq_flags = ETH_TXQ_FLAGS_NOXSUMSCTP" to be able to
use vmxnet3.
+cc vmxnet3 maintainer
>
> Regards,
> Chetan Bhasin
>
> On Tue, Oct 9, 2018 at 7:11 AM Chas Williams <3ch...@gmail.com> wrote:
>
>> Any other error messages? There's really only one path out of
>> slave_configure() that doesn't emit another error message and
>> that's slave_configure_slow_queue. You need to set dedicated_queues to
>> be enabled to see that happen.
>>
>> On 10/07/18 01:12, chetan bhasin wrote:
>>> Can anybody suggest? Stuck right now!
>>>
>>> On Sat, Oct 6, 2018, 17:02 chetan bhasin <chetan.bhasin...@gmail.com>
>> wrote:
>>>
>>>> Hi Dpdk Champs,
>>>>
>>>> I am facing an issue while bringing bonding on VM having vmxnet3
>>>> interfaces.
>>>>
>>>> Below error is coming in the log -
>>>>
>>>> PMD: bond_ethdev_start(1959) - bonded port (2) failed to reconfigure
>> slave
>>>> device (0).
>>>>
>>>> Please suggest.
>>>>
>>>> Thanks,
>>>> Chetan Bhasin
>>>>
>>
