On Fri, 2018-08-24 at 12:23 +0800, Tiwei Bie wrote:
> On Thu, Aug 23, 2018 at 01:52:25PM +0100, Luca Boccassi wrote:
> > On Tue, 2018-08-21 at 10:40 +0800, Tiwei Bie wrote:
> > > On Mon, Aug 20, 2018 at 05:45:35PM +0100, Luca Boccassi wrote:
> > > > On Mon, 2018-08-20 at 16:18 +0800, Tiwei Bie wrote:
> > > > > On Thu, Aug 16, 2018 at 07:49:43PM +0100, Luca Boccassi
> > > > > wrote:
> > > > > > On Thu, 2018-08-16 at 19:47 +0100, Luca Boccassi wrote:
> > > > > > > From: Brian Russell <bruss...@brocade.com>
> > > > > > >
> > > > > > > In virtio_read_caps and vtpci_msix_detect,
> > > > > > > rte_pci_read_config
> > > > > > > returns
> > > > > > > the number of bytes read from PCI config or < 0 on error.
> > > > > > > If less than the expected number of bytes are read then
> > > > > > > log
> > > > > > > the
> > > > > > > failure and return rather than carrying on with garbage.
> > > > > > >
> > > > > > > Fixes: 6ba1f63b5ab0 ("virtio: support specification 1.0")
> > > > > > >
> > > > > > > Signed-off-by: Brian Russell <bruss...@brocade.com>
> > > > > > > Signed-off-by: Luca Boccassi <bl...@debian.org>
> > > > > > > ---
> > > > > > > v2: handle additional rte_pci_read_config incomplete
> > > > > > > reads
> > > > > > >
> > > > > > > drivers/net/virtio/virtio_pci.c | 35
> > > > > > > +++++++++++++++++++++
> > > > > > > ----
> > > > > > > ----
> > > > > > > ----
> > > > > > > 1 file changed, 22 insertions(+), 13 deletions(-)
> > > > > > >
> > > > > > > diff --git a/drivers/net/virtio/virtio_pci.c
> > > > > > > b/drivers/net/virtio/virtio_pci.c
> > > > > > > index 6bd22e54a6..ff6f96f361 100644
> > > > > > > --- a/drivers/net/virtio/virtio_pci.c
> > > > > > > +++ b/drivers/net/virtio/virtio_pci.c
> > > > > >
> > > > > > ...
> > > > > > > @@ -610,9 +613,13 @@ virtio_read_caps(struct
> > > > > > > rte_pci_device
> > > > > > > *dev,
> > > > > > > struct virtio_hw *hw)
> > > > > > > hw->common_cfg =
> > > > > > > get_cfg_addr(dev,
> > > > > > > &cap);
> > > > > > > break;
> > > > > > > case VIRTIO_PCI_CAP_NOTIFY_CFG:
> > > > > > > - rte_pci_read_config(dev, &hw-
> > > > > > > > notify_off_multiplier,
> > > > > > >
> > > > > > > - 4, pos +
> > > > > > > sizeof(cap));
> > > > > > > - hw->notify_base =
> > > > > > > get_cfg_addr(dev,
> > > > > > > &cap);
> > > > > > > + /* Avoid half-reads into hw */
> > > > > > > + ret = rte_pci_read_config(dev,
> > > > > > > &multiplier,
> > > > > > > 4,
> > > > > > > + pos +
> > > > > > > sizeof(cap));
> > > > > > > + if (ret == 4) {
> > > > > > > + hw-
> > > > > > > >notify_off_multiplier =
> > > > > > > multiplier;
> > > > > > > + hw->notify_base =
> > > > > > > get_cfg_addr(dev,
> > > > > > > &cap);
> > > > > > > + }
> > > > > > > break;
> > > > > > > case VIRTIO_PCI_CAP_DEVICE_CFG:
> > > > > > > hw->dev_cfg = get_cfg_addr(dev,
> > > > > > > &cap);
> > > > > >
> > > > > > Tiwei: not 100% sure what's the best way to handle a
> > > > > > failure
> > > > > > here,
> > > > > > this
> > > > > > will avoid writing to *hw in case of errors. Let me know if
> > > > > > this is
> > > > > > OK.
> > > > >
> > > > > My concern is about reading the virtio capability directly.
> > > > > With this patch, it will give up reading other capabilities
> > > > > when failed to read a full virtio PCI capability structure
> > > > > (the returned bytes are less than the expected bytes) even
> > > > > though when the capability it's reading isn't a virtio vendor
> > > > > specific capability. I'm not quite sure whether it will bring
> > > > > any bad consequence. How about just reading the first two
> > > > > bytes first? Something like this:
> > > > >
> > > > > https://github.com/freebsd/freebsd/blob/72445a41b3ff/sys/dev/
> > > > > pci/
> > > > > pci.
> > > > > c#L1491-L1497
> > > >
> > > > I'm not sure, to be honest. That bit didn't give me trouble at
> > > > all,
> > > > so
> > > > at this point I'd much rather leave it alone so that the
> > > > maintainers
> > > > can take care of it how they see fit, if necessary :-)
> > > >
> > > > I've sent a v3 that removes that individual change.
> > >
> > > My concern isn't about the above change (which handled the
> > > errors when reading multiplier). In fact, above change looks
> > > good to me! :-) I mean the below changes in this patch:
> > >
> > > while (pos) {
> > > ret = rte_pci_read_config(dev, &cap,
> > > sizeof(cap),
> > > pos);
> > > - if (ret < 0) {
> > > - PMD_INIT_LOG(ERR,
> > > - "failed to read pci cap at pos:
> > > %x",
> > > pos);
> > > + if (ret != sizeof(cap)) {
> > > + PMD_INIT_LOG(DEBUG,
> > > + "failed to read pci cap at
> > > pos:
> > > %x ret %d",
> > > + pos, ret);
> > > break;
> > > }
> > >
> > > With this change, it will give up reading other capabilities
> > > when failed to read a full virtio PCI capability structure
> > > (the returned bytes are less than the expected bytes) even
> > > though when the capability it's reading isn't a virtio vendor
> > > specific capability. Maybe it would be better to read the
> > > first two bytes first and check whether it's the capability
> > > we want to parse (i.e. vendor capability and MSIX capability).
> > > Something like this:
> > >
> > > https://github.com/freebsd/freebsd/blob/72445a41b3ff/sys/dev/pci/
> > > pci.
> > > c#L1491-L1497
> > >
> > > How do you think?
> > >
> > > Thanks
> >
> > Ah I see what you mean now, sorry. Would something like the
> > following
> > be what you are looking for:
> >
> > ret = rte_pci_read_config(dev, &cap, 2, pos);
> > if (ret != 2) {
> > PMD_INIT_LOG(DEBUG,
> > "failed to read pci cap at pos: %x
> > ret %d",
> > pos, ret);
> > break;
> > }
> > if (cap.cap_vndr != PCI_CAP_ID_MSIX &&
> > cap.cap_vndr != PCI_CAP_ID_VNDR) {
> > goto next;
> > }
> >
> > ret = rte_pci_read_config(dev, &cap, sizeof(cap), pos);
> > if (ret != sizeof(cap)) {
> > PMD_INIT_LOG(DEBUG,
> > "failed to read pci cap at pos: %x
> > ret %d",
> > pos, ret);
> > break;
> > }
> >
>
> Yeah, that's what I want. :-)
> Just one nit, we don't need to read it as a
> virtio cap when dealing with the MSIX cap.
> When dealing with the MSIX cap, we just need
> to read the next two bytes:
>
> https://github.com/DPDK/dpdk/blob/7281cf520f89/drivers/net/virtio/vir
> tio_pci.c#L584-L594
> https://github.com/freebsd/freebsd/blob/59e4185a9358/sys/dev/pci/pci.
> c#L892
>
> Thanks!
Ok, done, see v4.
--
Kind regards,
Luca Boccassi
