Since the tested virtual device has no capacity of HW CRC offload,
disable it for the link bonding test by default. Otherwise, it will
cause test unexpected failure.
Fixes: b219c8c("test: enable HW CRC strip by default")
Signed-off-by: Phil Yang <phil.y...@arm.com>
---
test/test/test_link_bonding.c | 18 ++++--------------
1 file changed, 4 insertions(+), 14 deletions(-)
diff --git a/test/test/test_link_bonding.c b/test/test/test_link_bonding.c
index 0ffd650..d996c02 100644
--- a/test/test/test_link_bonding.c
+++ b/test/test/test_link_bonding.c
@@ -137,14 +137,8 @@ static uint16_t vlan_id = 0x100;
struct rte_eth_rxmode rx_mode = {
.max_rx_pkt_len = ETHER_MAX_LEN, /**< Default maximum frame length. */
- .split_hdr_size = 0,
- .header_split = 0, /**< Header Split disabled. */
- .hw_ip_checksum = 0, /**< IP checksum offload disabled. */
- .hw_vlan_filter = 1, /**< VLAN filtering enabled. */
- .hw_vlan_strip = 1, /**< VLAN strip enabled. */
- .hw_vlan_extend = 0, /**< Extended VLAN disabled. */
- .jumbo_frame = 0, /**< Jumbo Frame Support disabled. */
- .hw_strip_crc = 1, /**< CRC stripping by hardware enabled. */
+ .offloads = 0,
+ .ignore_offload_bitfield = 1,
};
struct rte_fdir_conf fdir_conf = {
@@ -158,12 +152,8 @@ static struct rte_eth_conf default_pmd_conf = {
.rxmode = {
.mq_mode = ETH_MQ_RX_NONE,
.max_rx_pkt_len = ETHER_MAX_LEN,
- .split_hdr_size = 0,
- .header_split = 0, /**< Header Split disabled */
- .hw_ip_checksum = 0, /**< IP checksum offload enabled */
- .hw_vlan_filter = 0, /**< VLAN filtering disabled */
- .jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 1, /**< CRC stripped by hardware */
+ .offloads = 0,
+ .ignore_offload_bitfield = 1,
},
.txmode = {
.mq_mode = ETH_MQ_TX_NONE,
--
2.7.4
