2014-08-26 15:31, Jijiang Liu:
> +enum rte_tunnel_filter_type {
> + RTE_TUNNEL_FILTER_TYPE_NONE = 0,
> + RTE_TUNNEL_FILTER_IMAC_IVLAN, /**< Filter by inner MAC and VLAN ID. */
> + RTE_TUNNEL_FILTER_IMAC_IVLAN_TENID,
> + /**< Filter by inner MAC address and VLAN ID, tenned ID. */
> + RTE_TUNNEL_FILTER_IMAC_TENID, /**< Filter by inner MAC and tenant ID. */
> + RTE_TUNNEL_FILTER_IMAC, /**< Filter by inner MAC address */
> + RTE_TUNNEL_FILTER_OMAC_TENID_IMAC,
> + /**< Filter by outer MAC address, tenant ID and Inner MAC */
> + RTE_TUNNEL_FILTER_TYPE_MAX,
> +};
[...]
> /**
> + * Tunnel Packet filter configuration.
> + */
> +struct rte_eth_tunnel_filter_conf {
> + struct ether_addr *outer_mac; /**< Outer MAC address fiter. */
> + struct ether_addr *inner_mac; /**< Inner MAC address fiter. */
> + uint16_t inner_vlan; /**< Inner VLAN fiter. */
> + enum rte_tunnel_iptype ip_type; /**< IP address type. */
> + union {
> + uint32_t ipv4_addr; /**< IPv4 source address to match. */
> + uint32_t ipv6_addr[4]; /**< IPv6 source address to match. */
> + } ip_addr; /**< IPv4/IPv6 source address to match (union of above). */
> +
> + uint8_t filter_type; /**< Filter type. */
> + uint8_t to_queue; /**< Use MAC and VLAN to point to a
> queue. */
> + enum rte_eth_tunnel_type tunnel_type; /**< Tunnel Type. */
> + uint32_t tenant_id; /** < Tenant number. */
> + uint16_t queue_id; /** < queue number. */
> +};
[...]
> +typedef int (*eth_tunnel_filter_set_t)(struct rte_eth_dev *dev,
> + struct rte_eth_tunnel_filter_conf
> *tunnel_filter,
> + uint8_t filter_count, uint8_t add);
> +/**< @internal Set tunnel filter */
[...]
> + /**
> + * Add tunnel filter configuration of Ethernet device
> + *
> + * @param port_id
> + * The port identifier of the Ethernet device.
> + * @param tunnel_filter
> + * Where to store the current Tunneling UDP configuration
> + * of the Ethernet device.
> + * @param filter_count
> + * How many filters are going to added.
> + * @param add
> + * 0: remove tunnel filter
> + * 1: add tunnel filter
> + *
> + * @return
> + * - (0) if successful.
> + * - (-ENODEV) if port identifier is invalid.
> + * - (-EINVAL) if bad parameter.
> + * - (-ENOTSUP) if hardware doesn't support tunnel type.
> + */
> +int
> +rte_eth_dev_tunnel_filter_set(uint8_t port_id,
> + struct rte_eth_tunnel_filter_conf *tunnel_filter,
> + uint8_t filter_count, uint8_t add);
I wonder if we could use a common function to set all kind of filters?
Thoughts are welcome.
--
Thomas
