It looks like SmarterMail may be grabbing the message before Declude can move it or make the changes needed, which seems to be a lot of the type problems you are facing. I would suggest trying the 3.0 release, if this solves your problem great if not it is always easy to revert to 2.0.6.16 by stopping the decludeproc service and renaming the declude.exe.
If you are going to do an upgrade be sure to read the instructions. David Barker www.declude.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gary Steiner Sent: Tuesday, September 27, 2005 6:06 PM To: [email protected] Subject: RE: [Declude.JunkMail] opening a ticket with Declude support David, As per our past off-the-list discussion, I had re-lowered the times to 120, but when this sudden increase of spam occurred yesterday, I raised them back up to 300. It doesn't seem to have had any effect. Gary -------- Original Message -------- > From: "David Barker" <[EMAIL PROTECTED]> > Sent: Tuesday, September 27, 2005 6:01 PM > To: [email protected] > Subject: RE: [Declude.JunkMail] opening a ticket with Declude support > > Gary, > > Are your timings in your SmarterMail (command line time out) and > (command > timeout) set to 300 or have you lowered the time? > > David Barker > www.declude.com > > > > --- [This E-mail scanned for viruses by Declude Virus] --- This E-mail came from the Declude.JunkMail mailing list. To unsubscribe, just send an E-mail to [EMAIL PROTECTED], and type "unsubscribe Declude.JunkMail". The archives can be found at http://www.mail-archive.com. --- This E-mail came from the Declude.JunkMail mailing list. To unsubscribe, just send an E-mail to [EMAIL PROTECTED], and type "unsubscribe Declude.JunkMail". The archives can be found at http://www.mail-archive.com.
