Unfortunately, I tried 2.4bf with no luck. It includes eepro100, which fails, but not e100 (as far as I could tell).
Thanks though. ---------------------------------------------------------------------- Andrew J Perrin - http://www.unc.edu/~aperrin Assistant Professor of Sociology, U of North Carolina, Chapel Hill [EMAIL PROTECTED] * andrew_perrin (at) unc.edu On Tue, 16 Sep 2003, Rich Puhek wrote: > > Andrew Perrin wrote: > > > Greetings- > > > > Setting up a new computer (an IBM NetVista) that has an Intel 10/100 VE > > adapter built in, I'm unable to use a net install. > > > > What I did was to burn a CD with the vanilla kernel setup, and boot to it. > > I can boot fine, but when I try to load the eepro100 module, I get > > "init_module: no such device" or "init_module: device or resource busy". > > Without that, I can't start the network, so I can't do the net install. > > > > Any advice on this? I thought eepro100 would work, even if e100 is > > probably the ultimate better choice. e100 is available only as source, so > > I can't use it to do the net install (right?). > > > > I thought that the 2.4bf image had both? If so, you should be able to do > the net install that way. Might want to give that a try... > > --Rich > > _________________________________________________________ > > Rich Puhek > ETN Systems Inc. > 2125 1st Ave East > Hibbing MN 55746 > > tel: 218.262.1130 > email: [EMAIL PROTECTED] > _________________________________________________________ > > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
