Greetings- Setting up a new computer (an IBM NetVista) that has an Intel 10/100 VE adapter built in, I'm unable to use a net install.
What I did was to burn a CD with the vanilla kernel setup, and boot to it. I can boot fine, but when I try to load the eepro100 module, I get "init_module: no such device" or "init_module: device or resource busy". Without that, I can't start the network, so I can't do the net install. Any advice on this? I thought eepro100 would work, even if e100 is probably the ultimate better choice. e100 is available only as source, so I can't use it to do the net install (right?). /proc/pci shows the adapter as PCI device 8086:1039, IO=0x300, IRQ=20. Thanks for any advice (including that I should just download complete ISO's and forget the net install). Andy ---------------------------------------------------------------------- Andrew J Perrin - http://www.unc.edu/~aperrin Assistant Professor of Sociology, U of North Carolina, Chapel Hill [EMAIL PROTECTED] * andrew_perrin (at) unc.edu -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
