Camaleón wrote:
On Wed, 28 Jul 2010 10:41:52 -0500, hugo vanwoerkom wrote:
Camaleón wrote:
(...)
I would try first to get an accurate temperature measure for the CPU
(69° C is a bit high, even for a laptop, but not critical -that depends
on the microprocessor type-). Are you able to get these values from
BIOS? Just to make a comparison...
'sensors-detect' gets:
Sorry, no sensors were detected.
Either your sensors are not supported, or they are connected to an I2C
or SMBus adapter that is not supported. See
http://www.lm-sensors.org/wiki/FAQ/Chapter3 for further information.
Did you read the suggested steps?
http://www.lm-sensors.org/wiki/FAQ/Chapter3#Sensors-detectdoesntworkatall
Mmm, does not look good.
You can try to load the latest SystemRescueCD (a livecd) which has the
latest version for "lm-sensors" package. If running "sensors-detect"
there either works, then... dunno :-/
BIOS shows nothing of either fan or temperature.
Ouch :-(
The only temperature indicators are
h...@debian:~$ cat /sys/class/thermal/thermal_zone0/temp 66000
h...@debian:~$ cat /sys/class/thermal/thermal_zone1/temp 50000
It is not clear what these refer to.
Thermal zones are "points" defined to "ring the bell" (getting an alarm
and provide an event → i.e., activating or speeding up the fan) to avoid
overheating, but provided that your ACPI detection is not very accurate,
I won't take that values very seriously.
'fancontrol' is shown as part of the package lm-sensors.
Yes :-(
Lenny has only 2.6.26 kernel. I can try knoppix 6.2.1 which has a 2.6.32
kernel and see if it has a later lm-sensors.
Lenny has version 3.0.2 and sid has 3.1.2, don't know if that will make
much difference.
Hugo
--
To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive: http://lists.debian.org/i2pr8f$hg...@dough.gmane.org
