Hello,
I am running etch and I have a pleomax pwc-2100 webcam by Pixart Imaging
Inc. The pwc-2100 doesn't run out the box. After googling a bit, I found
that it needs the gspca module. I installed the gspca-source and
followed the instructions in /usr/share/doc/gspca-source/readme.debian:
$ m-a prepare
$ m-a a-i gspca
the process ends with errors. Looking at the log file in the
module-assistant log file viewer, I found the following lines which
report errors:
scripts/Makefile.build:46: *** CFLAGS was changed in
"/usr/src/modules/gsp (<-----line is out of margins here)
make[3]: *** [_module_/usr/src/modules/gspca] Error 2
make[3]: Leaving directory '/usr/src/linux-headers-2.6.26-bpo.1-686'
make[2]: *** [default] Error 2
make[2]: Leaving directory '/usr/src/modules/gspca'
make[1]: *** [binary-modules] Error 2
make[1]: Leaving directory '/usr/src/modules/gspca'
make: *** [kdist-build] Error 2
I never used module-assistant before. Any help will be very much
appreciated!
Marcelo
--
Marcelo Chiapparini
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
