On Tuesday 15 May 2007 16:13, Florian Kulzer wrote:
> On Tue, May 15, 2007 at 07:32:11 +0000, Tim Johnson wrote:
> > On Tuesday 15 May 2007 07:20, Florian Kulzer wrote:
>
> [...]
>
> > > I had a look at the dmesg output which you linked in your original
> > > message. I saw that you also have references to "tulip0" in there. How
> > > many network interface cards are in that computer? (see "lspci")
> >
> > Just one now.
>
> "Now" as in "but there were more earlier"? (This is probably only
> relevant if you changed the hardware after you had installed Debian.)
The hardware was changed _before_ install. Sorry.
> > line below:
> > ##
> > 01:05.0 Ethernet controller: Davicom Semiconductor, Inc. 21x4x DEC-Tulip
> > compatible 10/100 Ethernet (rev 31)
> > ##
>
> I would also like to see the output of:
>
> /sbin/ifconfig
## ----------------------------------------------------------
eth0 Link encap:Ethernet HWaddr 00:80:AD:79:35:E1
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::280:adff:fe79:35e1/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:28 errors:248 dropped:0 overruns:0 frame:0
TX packets:26 errors:6 dropped:0 overruns:0 carrier:6
collisions:0 txqueuelen:1000
RX bytes:3055 (2.9 KiB) TX bytes:2492 (2.4 KiB)
Interrupt:217 Base address:0xbc00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:50 errors:0 dropped:0 overruns:0 frame:0
TX packets:50 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:5152 (5.0 KiB) TX bytes:5152 (5.0 KiB)
## ----------------------------------------------------------------------
> lsmod | egrep 'tulip|de2104x|de4x5'
tulip 57120 0
> cat /etc/udev/rules.d/z25_persistent-net.rules
on one line between '*'
************************************************************
SUBSYSTEM=="net", DRIVERS=="?*",
ATTRS{address}=="00:80:9d:79:35:e1", NAME="eth"
************************************************************
tim
--
Tim Johnson <[EMAIL PROTECTED]>
Palmer, Alaska, USA
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
