On Tue, May 15, 2007 at 09:15:22 +0000, Tim Johnson wrote:
> On Tuesday 15 May 2007 16:13, Florian Kulzer wrote:
> > On Tue, May 15, 2007 at 07:32:11 +0000, Tim Johnson wrote:
[...]
> > I would also like to see the output of:
> >
> > /sbin/ifconfig
> ## ----------------------------------------------------------
> eth0 Link encap:Ethernet HWaddr 00:80:AD:79:35:E1
> inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
> inet6 addr: fe80::280:adff:fe79:35e1/64 Scope:Link
> UP BROADCAST MULTICAST MTU:1500 Metric:1
> RX packets:28 errors:248 dropped:0 overruns:0 frame:0
> TX packets:26 errors:6 dropped:0 overruns:0 carrier:6
> collisions:0 txqueuelen:1000
> RX bytes:3055 (2.9 KiB) TX bytes:2492 (2.4 KiB)
> Interrupt:217 Base address:0xbc00
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> inet6 addr: ::1/128 Scope:Host
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:50 errors:0 dropped:0 overruns:0 frame:0
> TX packets:50 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:5152 (5.0 KiB) TX bytes:5152 (5.0 KiB)
> ## ----------------------------------------------------------------------
> > lsmod | egrep 'tulip|de2104x|de4x5'
>
> tulip 57120 0
> > cat /etc/udev/rules.d/z25_persistent-net.rules
> on one line between '*'
> ************************************************************
> SUBSYSTEM=="net", DRIVERS=="?*",
> ATTRS{address}=="00:80:9d:79:35:e1", NAME="eth"
^ ^
> ************************************************************
"address" does not match "HWaddr" in the ifconfig output and NAME should
be assigned as "eth0". I am afraid that these are just transcription
errors again, though.
You seem to have many errors, especially for RX packets. This might
indicate a general problem with the driver or a flaky ethernet cable.
--
Regards, | http://users.icfo.es/Florian.Kulzer
Florian |
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
