On Mon, Jul 07, 2003 at 11:44:27AM +0100, Colin Watson wrote: > On Mon, Jul 07, 2003 at 12:16:53PM +0200, Qian Gong wrote: > > I installed CUPS under woody. Configuration works well under Mozilla. > > But the command "enable" always fails, as shown below. > > > > enable fp > > bash: enable: fp: not a shell builtin > > enable is a built-in command in bash. CUPS' choice of command name here > was somewhat unwise. > > $ help enable > enable: enable [-pnds] [-a] [-f filename] [name ...] > Enable and disable builtin shell commands. This allows > you to use a disk command which has the same name as a shell > builtin without specifying a full pathname. If -n is used, the > NAMEs become disabled; otherwise NAMEs are enabled. For example, > to use the `test' found in $PATH instead of the shell builtin > version, type `enable -n test'. On systems supporting dynamic > loading, the -f option may be used to load new builtins from the > shared object FILENAME. The -d option will delete a builtin > previously loaded with -f. If no non-option names are given, or > the -p option is supplied, a list of builtins is printed. The > -a option means to print every builtin with an indication of whether > or not it is enabled. The -s option restricts the output to the POSIX.2 > `special' builtins. The -n option displays a list of all disabled builtins. > > Try '/usr/bin/enable' or (I think) 'cupsenable' instead.
The above suggestion works properly. Thanks a lot. Qian -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
