On Mon, Jul 07, 2003 at 12:16:53PM +0200, Qian Gong wrote:
> I installed CUPS under woody. Configuration works well under Mozilla.
> But the command "enable" always fails, as shown below.
>
> enable fp
> bash: enable: fp: not a shell builtin
enable is a built-in command in bash. CUPS' choice of command name here
was somewhat unwise.
$ help enable
enable: enable [-pnds] [-a] [-f filename] [name ...]
Enable and disable builtin shell commands. This allows
you to use a disk command which has the same name as a shell
builtin without specifying a full pathname. If -n is used, the
NAMEs become disabled; otherwise NAMEs are enabled. For example,
to use the `test' found in $PATH instead of the shell builtin
version, type `enable -n test'. On systems supporting dynamic
loading, the -f option may be used to load new builtins from the
shared object FILENAME. The -d option will delete a builtin
previously loaded with -f. If no non-option names are given, or
the -p option is supplied, a list of builtins is printed. The
-a option means to print every builtin with an indication of whether
or not it is enabled. The -s option restricts the output to the POSIX.2
`special' builtins. The -n option displays a list of all disabled builtins.
Try '/usr/bin/enable' or (I think) 'cupsenable' instead.
Cheers,
--
Colin Watson [EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
