Hi list, A small annoyance: for a few months now, my etch box stops booting at a particular point, whereupon I must hit return, and it then completes. I am not entirely sure, but I think that the last change I made was to install insserv, the parallel booting service.
The last messages displayed when the boot stops are usually: [........] Jan 25 20:18:42 tpad kernel: ACPI: AC Adapter [AC] (on-line) Jan 25 20:18:42 tpad kernel: ACPI: CPU0 (power states: C1[C1] C2[C2] C3[C3]) Jan 25 20:18:42 tpad kernel: ACPI: Processor [CPU] (supports 8 throttling states) Jan 25 20:18:42 tpad kernel: Time: acpi_pm clocksource has been installed. Jan 25 20:18:42 tpad kernel: ACPI: Power Button (FF) [PWRF] Jan 25 20:18:42 tpad kernel: ACPI: Lid Switch [LID] Jan 25 20:18:42 tpad kernel: ACPI: Sleep Button (CM) [SLPB] Jan 25 20:18:42 tpad kernel: ACPI: Thermal Zone [THM0] (27 C) After I hit return, these messages appear next, and booting concludes normally: Jan 25 20:18:42 tpad kernel: e100: ethernet: e100_watchdog: link up, 100Mbps, full-duplex Jan 25 20:18:42 tpad kernel: NET: Registered protocol family 10 Jan 25 20:18:42 tpad kernel: lo: Disabled Privacy Extensions Jan 25 20:18:42 tpad kernel: ADDRCONF(NETDEV_UP): wireless: link is not ready Jan 25 20:18:42 tpad kernel: IPv6 over IPv4 tunneling driver Jan 25 20:18:42 tpad ifplugd.agent[3331]: Invoking ifplugd for sit0 Jan 25 20:18:42 tpad kernel: sit0: Disabled Privacy Extensions Jan 25 20:18:46 tpad dhcdbd: Started up. Jan 25 20:18:47 tpad kernel: Capability LSM initialized [......] Sometimes there is a difference of a line or two from what is shown above. Does anyone know how I might go about diagnosing this further? Regards, John -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
