On Wednesday 13 December 2006 08:52, Mirto Silvio Busico wrote:
> Andrei Popescu ha scritto:
> > On Wed, Dec 13, 2006 at 08:08:57PM +1300, Simon wrote:
> >> Hi There,
> >>
> >> Is there a way to set network cards to full duplex at boot time?
> >>
> >> Thanks Simon
> >
> > Mine is set that way automatically. It would be helpful if you would
> > specify which card and chipset, Debian release, kernel version, ...
> >
> > Regards,
> > Andrei
>
> Well, I have a switch that doesn' t work well with negotiation. So I
> added these MII lines in /etc/init.d/networking (in the start section):
>
> ======================================================
> start)
> process_options
> log_action_begin_msg "Configuring network interfaces"
> if ifup -a; then
> log_action_end_msg $?
> else
> log_action_end_msg $?
> fi
> /sbin/mii-tool -F 100BaseTx-HD eth0
> /sbin/mii-tool -v eth0
> ;;
> ======================================================
>
> These have to be done for every network card (HD stays for Half Duplex,
> you need FD - Full Duplex - see the mii-tool manual).
> For me this works.
Theoretically you could also add a line:-
up mii-tool -F 100BaseTx-FD eth0
to /etc/networking/interfaces. BUT this does not always work, and some
have suggested:-
up sleep 30; mii-tool -F 100BaseTx-FD eth0
Some drivers also support parameters that will force the speed and duplex
settings, but the tg3 driver for one does not.
Some drivers do not work well with mii-tool, for those try ethtool.
David
>
> Regards
> Mirto
>
> --
>
> __________________________________________________________
> Mirto Silvio Busico ICT Consultant
> Tel. +39 333 4562651
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
